Register

Adv. Query

Q&A (4871)

Reviews (203)

Open problems (47)
Meta (439)

Site Statistics

205 submissions , 163 unreviewed
5,082 questions , 2,232 unanswered
5,353 answers , 22,789 comments
1,470 users with positive rep
820 active unimported users
More ...

How to calculate the steps needed for a motor to rotate a circular object in a pulley configuration?

940 views

I have a stepper motor with 200 steps per revolution and a pulleys configuration as following: 3 pulleys with 100 mm diameter each on 1184 mm PCD and are equally spaced (120 degrees) from each other. A large ring with a diameter of 1074 mm is placed on the center on the pulleys configuration (center of ring to center of each pulley is 592 mm). A belt of 3626.5 mm length and 30 mm width is positioned around the pulleys and contacts the ring. The motor is installed vertically on the bottom of one of the pulleys (concentric on the same axis). I want to know how many steps it takes for the motor in order to have a full revolution on the large ring.

Closed as per community consensus as the post is low-level

asked May 18, 2015 in Closed Questions by Pulley [ revision history ]
recategorized May 18, 2015 by dimension10

Hi Pulley,

PhysicsOverflow is a graduate-level upward physics site, but this seems to be a basic school physics question.

I am therefore voting to close.

A better place to ask this might for example be Quora or PhysicsForums.

commented May 18, 2015 by Dilaton (6,240 points) [ revision history ]
edited May 20, 2015 by Dilaton

Hi Dilaton,

Apologies; this is my first time visiting this site and didn't pay full attention to the aim of it.

Nonetheless, appreciating your recommendations.

Regards

commented May 19, 2015 by anonymous [ no revision ]

Your comment on this question:

To answer, leave an answer instead. Comments are usually for non-answers.
To mask links under text, please type your text, highlight it, and click the "link" button. You can then enter your link URL.
To alert a user, please use the "@" command and remove spaces from the username, example, the user "John Doe" should be pinged as "@JohnDoe", while the user "Johndoe" should be pinged as "@Johndoe". The post author is always automatically pinged (unless you are the post author).
Please consult the FAQ for as to how to format your post.

Live preview (may slow down editor) Preview

Your name to display (optional):

Email me at this address if a comment is added after mine:

Privacy: Your email address will only be used for sending these notifications.

Anti-spam verification:

If you are a human please identify the position of the character covered by the symbol $\varnothing$ in the following word:
p$\hbar$ysicsOverflo$\varnothing$
Then drag the red bullet below over the corresponding character of our banner. When you drop it there, the bullet changes to green (on slow internet connections after a few seconds).

Please complete the anti-spam verification

user contributions licensed under cc by-sa 3.0 with attribution required

Your rights

...